Mechanical breakdown due to poor maintenance.Īccidents and injuries due to improperly working equipment. Follow your company's procedures.įorklift skidding or sliding due to grease, leakage, spills. Never operate a forklift requiring maintenance, and always report repair problems to your supervisor. Scheduled maintenance is critically important to the safe operation of your vehicle. No truck shall be operated with a leak in the fuel system until the leak has been corrected. When the temperature of any part of any truck is found to be in excess of its normal operating temperature, thus creating a hazardous condition, the vehicle shall be removed from service and not returned to service until the cause for such overheating has been eliminated. Īny vehicle that emits hazardous sparks or flames from the exhaust system shall immediately be removed from service, and not returned to service until the cause for the emission of such sparks and flames has been eliminated. ĭefects when found must be immediately reported and corrected. All repairs shall be made by authorized personnel. If the operator notes these conditions while driving, the operator must stop, park the vehicle and get assistance.Īny powered industrial truck not in safe operating condition shall be removed from service. The OSHA powered industrial truck standard lists a number of conditions under which a forklift must be removed from service. While driving, be aware of these potential hazards: Note: Checklists are provided as a guide only and are not a substitute for complying with OSHA standards.Ĭhecklists for internal combustion and electric trucksĬhecklists for various truck types and sample generic checklist Sample Daily Checklists for Powered Industrial Trucks. Note: Always use personal protective equipment such as a face shield, long sleeves, and gauntlet gloves when checking liquid propane tanks and fittings. ![]() Note: Always use personal protective equipment such as a face shield, rubber apron, and rubber gloves when checking electrolyte. These include but are not limited to:Ĭables and connectors for frayed or exposed wires In addition to this general inspection, additional items should be checked depending on the forklift type (electric or internal combustion, including liquid propane). Check for grease and debris.Īll safety devices are working properly including the seat belt. Check that information on the nameplate matches the model and serial numbers and attachments. Ensure all warning decals and plates are in place and legible. Tire condition and pressure including cuts and gouges.Ĭondition of the forks, including the top clip retaining pin and heel. Use a stick or other device to check chain tension. NOTE: Operators should not place their hands inside the mast. Leaks, cracks or any other visible defect including hydraulic hoses and mast chains. Any problems should be recorded on the appropriate documents and reported to a supervisor.īefore starting your vehicle, conduct a pre-operation (or pre-start) inspection that checks a variety of items, including but not limited to:įluid levels - oil, water, and hydraulic fluid. Remember! A vehicle in need of repair, defective or in any way unsafe, should not be driven and should be taken out of service immediately. The forklift should not be placed in service if the examinations show that the vehicle may not be safe to operate. The operator should conduct a pre-start visual check with the key off and then perform an operational check with the engine running. Forklifts used on a round-the-clock basis must be examined after each shift. The employer failed to provide additional required training to the worker when he became a forklift assistant.OSHA requires that all forklifts be examined at least daily before being placed in service.The employer didn’t ensure the worker received appropriate training on operating a forklift.The forklift manufacturer’s instructions, which stated that passengers shouldn’t ride outside the cab, weren’t followed.The employer didn’t have a joint health and safety committee for the worksite, as required.“It can expose workers to dangers such as falling off, being struck by objects, or being crushed between the forklift and another object.” ![]() ![]() “Riding as a passenger on a forklift is prohibited in most cases,” WorkSafe BC says. The animation, produced by the Workers’ Compensation Board of British Columbia, details an incident in which a young worker at a rebar manufacturing facility was seriously injured after falling off a forklift while riding on the side of the equipment. Vancouver, British Columbia - A new forklift safety video illustrates why the equipment’s operator should be the only rider.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |